hi everyone!
i'm back with the machine assembled and up and running. the power supply works fine, so that part is done.
i'm close to my first test but the way things are: the y axis works perfectly. the z axis moves but up to a certain point only and the x is not moving at all. i hear the motor trying to move but nothing happens. the distance between the tray and the hot-end is about 10 milimetres and it's far too much.
all the slicer and movement controls are working, the heating is up and running, but i cant configure the machine until every axis is in place. plus the repetier on the first start said 'the splitter distance must be greater than 0' - what shall i do with it?
oh yes, i'm using the latest firmware and repetier-host -
any ideas?
close to the first test
Have you adjusted the pots on the stepper motor drivers?
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
See instruction manual page 42
http://www.felixprinters.com/downloads/ ... _5b_v2.pdf
http://www.felixprinters.com/downloads/ ... _5b_v2.pdf
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix