v1.5 Electronics

Help eachother out with assembly problems.
Post Reply
twicx
Posts: 105
Joined: Fri Jan 11, 2013 1:26 pm

v1.5 Electronics

Post by twicx »

Hey,
I've managed to make it through the majority of my 1.5 build with no major issues so far (other than burning myself with the soldering iron). I've come to the electronics, but the instructions in the 1.5 manual still seem to be for the 1.0 version. So, I should be fairly ok with getting through it, once I can actually get started. My question is that the big electronics case on the 1.5 is one covered piece. Does this mean that I do all the powersupply/ramps assembly and then put the powersupply and ramps into the box last before mounting it to the frame? or, is there an updated electronics module instruction I'm missing somewhere?
Cheers,
Neil

twicx
Posts: 105
Joined: Fri Jan 11, 2013 1:26 pm

Post by twicx »

never mind. just discovered that it's a lid.

/3dprintafacepalm

Post Reply