y-Axis tooth belt

Help eachother out with assembly problems.
Post Reply
MartenKL
Posts: 1
Joined: Tue Feb 19, 2013 11:20 pm

y-Axis tooth belt

Post by MartenKL »

In Instruction_Manual_of_Felix_1_5b_v2.pdf page 12. Last Illustration and text; the M4x25 bolt is too long for the order bearing, bearing, small washer, plastic part, small washer, self-locking nut. It also is different from first image second column on page 14. What am I misunderstanding?

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

The manual has a lot of old legacy pictures from the Felix 1.0 and early felix 1.5 version. The picture on page 14 is the old way, but sometimes the belt grinds along the big washer. So Felix printers updated the design with an extra bearing on top of the first one, and remove the big washers. So, just use a M4 bold that fits: bearing, bearing, small washer, plastic part, small washer, self-locking nut.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply