Hi,
I have just assembled my first Felix and trying to make calibration.
In software I have text "commands wainting". When I press reset button, nothing happened.
How I get cleaned these commands. I want go forward with this printer and get my first print out.
Command Waiting
Have you successfully uploaded the firmware using the Arduino software? If so, are you configured the right COM port and baud rate in Repetier host to communicate with the printer?
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
250000
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix