strange error

Post Reply
matteej
Posts: 23
Joined: Wed Oct 17, 2012 8:09 pm
Location: Netherlands
Contact:

strange error

Post by matteej »

error.png
after migrating the RAMPS to the new case this error started appearing.
suggestions?

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Looks like the thermistor in your hot-end had a short malfunction. And the printer stopped because of this. If this happens again, your thermistor might be broken, or there some kind of connection problem. There should be a reserve thermistor in the kit.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

matteej
Posts: 23
Joined: Wed Oct 17, 2012 8:09 pm
Location: Netherlands
Contact:

Post by matteej »

it happens randomly after a few minutes of printing.
I'll try replacing it, and see what happens

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

Also please check the connector on the ramps board if it is correctly placed. Try to wiggle the cables in that area and check if the error is coming back

matteej
Posts: 23
Joined: Wed Oct 17, 2012 8:09 pm
Location: Netherlands
Contact:

Post by matteej »

I finally got around to replacing the thermistor. The problem appears to be gone now :)
Thanks for the tip!

Post Reply