Changing from Dual to Single extruder

This is the place to show off your felix printer hacks and improvements.
Post Reply
Bobbystone
Posts: 23
Joined: Wed Feb 18, 2015 5:28 am

Changing from Dual to Single extruder

Post by Bobbystone »

I want to change my felix dual to a single extruder, and probably switch to a E3D hot end as well. What do I need to do to the firmware to make that work?

Thanks!

aikx
Posts: 45
Joined: Sun May 13, 2012 1:14 pm
Location: Cologne, Germany

Post by aikx »

Bobbystone wrote:... my felix dual ...
What Version?: 1,2,3,Pro?

Bobbystone
Posts: 23
Joined: Wed Feb 18, 2015 5:28 am

Post by Bobbystone »

Felix 3.0 Dual. Want to convert to single

aikx wrote:
Bobbystone wrote:... my felix dual ...
What Version?: 1,2,3,Pro?

Sander_Felix
Posts: 11
Joined: Tue Apr 19, 2016 9:06 am

Post by Sander_Felix »

The firmware for single extrusion can be found here: http://www.felixprinters.com/downloads/ ... 2FFELIX_3/

E3D hot end
In the following topic you can find information about the firmware:
http://www.felixprinters.com/forum/view ... f=9&t=1078

Forum member Satoer wrote an article about 'E3D V6 hotend easy maintenance carriage for Felix 3D printer' on Thingyverse:
http://www.thingiverse.com/thing:484581

Post Reply