Print stops suddenly

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
kimmoli
Posts: 62
Joined: Fri Mar 08, 2013 1:15 pm
Location: Finland

Print stops suddenly

Post by kimmoli »

I have issue where printing stops middle of printing, usually when the design has multiple stacked cylinders.
I can repeat this with attached g-code file; If there are any enthusiastic debuggers, you can try does your print halt:
jaakontappi.zip
Halting print g-code
(84.96 KiB) Downloaded 20 times
It will halt at about 10mm height - luckily this is small part.

I followed instructions in this tutorial, but were not able to restart printing, as it was interrupted in the very same position again even with stripped G-code.

After saying Disconnect-Connect from host, i was able to restart printing but without extrusion.

I added following code to the start of stripped g-code file, and printing was completed somewhat ok.
(part from the SFACT generated start code before the very first M101)

Code: Select all

G90
G21
G92 E0
M106
M82
M113 S1
M108 S1
G1 E1.5 F1800
I will try next to debug is print halt caused by USB, EMC issue, or Arduino firmware.

kimmoli
Posts: 62
Joined: Fri Mar 08, 2013 1:15 pm
Location: Finland

Post by kimmoli »

Solved (for now)

I did set Ping-ping communications from Printer Config dialog:
pingpong.jpg
And the print finalises nicely now.

Post Reply