Extruder trouble

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
killejano
Posts: 92
Joined: Mon Apr 01, 2013 7:23 pm

Re: Extruder trouble

Post by killejano »

The extruder is working fine now. Seem I had something in the hot end that clogged it up and allmost came out every time I pulled the filament out. Today I finally got the 0,35mm drillbits I ordered so I got it cleaned up properly. Previously the only thig I had that would fit in there was 0.2mm copper wire. Might be a nice idea to include drill bits with the printer as propably everyone needs one at some time.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Use a piece of guitar string!
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply