Felix Pro 1 don't calibrate.

Post Reply
FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Re: Felix Pro 1 don't calibrate.

Post by FunnyManNsk »

The magnet of the first extruder fell out when I magnetized it with a wrench.
But the message about the Z-sensor has not disappeared.

Help me find the reason please
Attachments
20170824_084001.jpg
20170824_084038.jpg

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

Hi Funnymansk, I've just send you an email with instructions.

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

Thank you! Hope to help and I can!

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

gfeliksdal wrote:Hi Funnymansk, I've just send you an email with instructions.
Checked the deflection of the hot end, corrected it - the effect is not stable.
I pasted the magnet back to the super glue (there is no other).
I noticed that the eye contact screw was loose.
Tried to tighten it, eventually got the following:
20170825_104731.jpg
this is very bad ?

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

Hi that doesn't look very good. Do you have a washer? With some fiddling you might be able to loosen the screw and place the ring terminal with washer back.

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

The problem is that I can not get close to the screw with a screwdriver, in front of it there is no hole through which it could be done

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

Dear, Guillaume Feliksdal!
Thank you for your help! The instruction from the mail helped, now everything looks good.

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

I started to rejoice early. The Z-sensor error continues to appear. It looks like you need to try to adjust the flexure

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

Many times I tried to calibrate the flexers of the hot end.
The size of the instruction 4,55-4,60 was not suitable, the Z-sensor earned when the size became 4.4 mm.
Switching on the sensor occurs at a weight of 1000 grams, shutting down when decreasing to 970 grams.

I tried to start the calibration of the table, but it did not work.
Here is the video of the error and how it happens:
https://youtu.be/DrXMlP7ODdA

FunnyManNsk
Posts: 22
Joined: Wed Aug 31, 2016 4:59 am

Post by FunnyManNsk »

How can I fix it "G32 leveling fail" ?
Why does it happend ?

Post Reply