How to remove printer inactivity timeout

Post Reply
Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

How to remove printer inactivity timeout

Post by Hugues »

Hi guys,

i would like to use my print bed as a heating plate, i need to keep it at 37 C all night,

But if i leave the printer connected to my PC with the bed heater on, after a certain time, the heater stops working, looks like there is a inactivity timeout somewhere.

I check the various configuration screen but i cannot find anything,

any idea ?
Hugues
Regards from Switzerland

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide »

Have you looked in the EEPROM settings (Config->Firmware EEPROM Config -> "Max Inactive Time" (at least for Repetier firmware)?
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues »

good idea,i'm going to check this

although i cannot connect to myprinter currently,i'll start another post on this

thanks
Hugues
Regards from Switzerland

Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues »

ok, found the parameter, seems to be working indeed
thanks
Hugues
Regards from Switzerland

Post Reply