The Prometheus System - Intuitive Multi-Filament 3D Printing

This is the place to show off your felix printer hacks and improvements.
Post Reply
jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

The Prometheus System - Intuitive Multi-Filament 3D Printing

Post by jjlink »

Anyone else going to try using the Prometheus System on a Felix 3.0 printer? I am expecting the main challenge will be designing a mount for it.

In case you don't know what it is here is the info:
https://www.distechautomation.com/colle ... eus-system
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

Post by jjlink »

I just got my Prometheus System; so now I need to figure out how to mount the Prometheus V2 Hot End.
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

User avatar
janwijbrand
Posts: 37
Joined: Thu Dec 24, 2015 4:22 pm

Post by janwijbrand »

I'm very curious for your mounting solution. I've considered getting the Prometheus as well, shipping costs are very steep though. Anyway, please let us know what results you achieve. It looks like a nice "upgrade" or "mod"!
Felix 3.1 single extruder, soon to be Tec 4 dual

jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

Post by jjlink »

janwijbrand wrote:I'm very curious for your mounting solution. I've considered getting the Prometheus as well, shipping costs are very steep though. Anyway, please let us know what results you achieve. It looks like a nice "upgrade" or "mod"!
I am thinking I might be able to use this thing to mount the Prometheus v2 hot end:

http://www.thingiverse.com/thing:81020

However I don't know what is needed to fix the hot end in place.
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

Post by jjlink »

I came up with this mount for the Prometheus System with the v2 hot-end.

http://www.thingiverse.com/thing:2268964

I still have to finish assembling the rest of the Prometheus System.
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

User avatar
janwijbrand
Posts: 37
Joined: Thu Dec 24, 2015 4:22 pm

Post by janwijbrand »

Looks promising!
Felix 3.1 single extruder, soon to be Tec 4 dual

Post Reply