Hi,
I have a FelixPrinters 3.1 dual-extruder printer with the following modifications:
1. Better bed-support. So the bed is supported at 5 points (middle + corners) -> bed can be leveled better.
2. Firmware replaced with Marlin (=better than original Repetier firmware in many aspects)
3. Buildtak flexplate system instaslled
4. BLTouch sensor -> auto bed leveling... no more manual tuning of Z-height.
I want to sell this printer and If you're interested, please let me know.
Thanks
Selling my FelixPrinter 3.1 + modifications
I would be interested too3Diy wrote:Hello ErikL,
I have a question:
can you share your modification you made to the cooling and your marlin firmware/configuration?
Im currently working on a advanced cooling system but till now i was unable to improve the print quality
