3D Printers Nozzle clogging Solution

Moderator: speedake95

Post Reply
Smh69
Posts: 3
Joined: Thu Mar 02, 2017 5:42 pm
Contact:

3D Printers Nozzle clogging Solution

Post by Smh69 »

By operating the software to close the nozzle, then remove the print head to leave the model;
The raw material from the nozzle clawed to prevent further congestion;
Remove the residual plastic from the nozzle;
Open the nozzle work, such as the nozzle inside the plastic melt will automatically spray;
New plastic materials plug in the nozzle;

When the 3D printer is on hold

(1) platform cleaning

Find a lint-free flannel, in the top with a little topical alcohol or some acetone nail polish cleaner, gently wipe, you can clean up the platform.

(2) residual material in the nozzle clean-up

Preheat the nozzle to about 220 ℃, and then use the tweezers to slowly pull out the waste silk, or remove the nozzle for a thorough clean-up.

(3) other clean-up

The 3D printer cabinet below the garbage clean up, to the lack of oil lubrication components, with a clean cloth to the motor, screw and other components above the oil wipe clean.
Do a good job cleaning up the above points, the machine can be covered after a good long-term storage. Equipment in the course of daily use, to develop good maintenance habits can extend its use of time.

steve3dprinters
Posts: 5
Joined: Wed Jul 18, 2018 8:00 am

Post by steve3dprinters »

I like the nozzle cleaning solutions but the advice to clean the platform before doing so is a good one. And I would also like to add that there are some other methods too which could be used effectively to unclog the clogged nozzles of your 3D printers.

Post Reply

Return to “Tips and Tricks”