Bed Temperature doesnt rise > Dec.

Post Reply
tingle3003
Posts: 2
Joined: Tue Jul 25, 2017 10:08 am

Bed Temperature doesnt rise > Dec.

Post by tingle3003 »

Hello everyone!

I have an Felix Pro 2 which has since some days a problem with the heated bed:

The sensor picks up the right temperature from the bed, but isnt willing to raise the temperature.
So after a while it keeps staying at the same temp, the displays shows a "dec" for the bed.

I already tried it with a second bed > same problem
I switched the little sensor board with the pins (from a second Felix) > same problem

So assume the problem is somewhere within the cable, or it is some software-failure.

Does anybody have a hint where I could check?
Hope you can help!
Best

tingle3003
Posts: 2
Joined: Tue Jul 25, 2017 10:08 am

Post by tingle3003 »

Ok - I found the solution finally for myself.

It was one of the red or black wires which connects to the board with the small golden pins. One of them must had a lil bit loose - so I pushed them a lil bit further into the connection plug and it worked again.

Post Reply