My Version of Felix 2.0 call it 2.5

This is the place to show off your felix printer hacks and improvements.
Post Reply
Hardy123
Posts: 12
Joined: Fri Jan 05, 2018 1:50 am

My Version of Felix 2.0 call it 2.5

Post by Hardy123 »

Here is my Felix Conversion :-)

Firmware Marlin Rc 1.1.8
Energy Chains
Mainboard Led housing shows the temperature ( green cold / purple middle / red hot )
Sensor is inside the Heatbed .

Dual Extruder with a Servo from Thingverse Dondolo V1
I Adapted the Plate for the Felix.

LED lighting Bar

After My Test the Dondolo Works not well !!!
Not Enought Pressure from Sensor !
Please Not Build this

greetings Hardy
Attachments
Add description
Add description
Add description
Add description
Add description
Add description
Add description
Add description
Last edited by Hardy123 on Thu Feb 28, 2019 11:04 pm, edited 1 time in total.

User avatar
janwijbrand
Posts: 37
Joined: Thu Dec 24, 2015 4:22 pm

Post by janwijbrand »

Nice conversion!
Felix 3.1 single extruder, soon to be Tec 4 dual

Gabrielber
Posts: 6
Joined: Fri Dec 22, 2017 2:51 pm

Post by Gabrielber »

Looking good! Is the custom dual extruder light enough or does it cause more ripples / ringing than usual?

Post Reply