leaking hotend Felix tec 4

This is the place to show off your felix printer hacks and improvements.
Post Reply
CesarineHiddink
Posts: 5
Joined: Sun Nov 26, 2017 2:21 pm

leaking hotend Felix tec 4

Post by CesarineHiddink »

When I'm printing with one of the extruders, left or right that is the same no difference, the prints are perfect. But when I try to print with both extruders, two different colors PLA, with support and Oozeshield, than the right one is leaking filament, both below and above. When I print with only the right extruder, it isn't leaking. What can I do to prevent this?
Because of this, the print is at the end not as beautiful as the print with one extruder.
Finally I want to print with PVA in one extruder for the support.

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

Hello Cesarine,
What slicing settings do you use? Do you see that the nozzles cool down during nozzle switching? If this is not the case, you will see this leakage.

CesarineHiddink
Posts: 5
Joined: Sun Nov 26, 2017 2:21 pm

Post by CesarineHiddink »

yes they are cooling down during switching till 130 C.

CesarineHiddink
Posts: 5
Joined: Sun Nov 26, 2017 2:21 pm

Post by CesarineHiddink »

bijgevoegd de slicings
Attachments
strakkearmband250118dualpla.gcode
(4.63 MiB) Downloaded 84 times

Post Reply