extruders skipping

Post Reply
evanr
Posts: 101
Joined: Thu Nov 29, 2012 3:09 am

extruders skipping

Post by evanr »

Frustrated. I just received my Pro2 touch yesterday. It did a great test print with the boat.

Then I wake up to print next day and I hear thumping from both extruders.

I did end up turning the power switch off just before it started to print once this morning..... could this have caused the problem?

It extrudes ok but after about 10sec starts to thump thump thump, then when it starts to print it doesn't extract much material?

Could it be the pot metre needs to be adjusted? Where is the arduino on the Pro2touch, how do I access it?

Any help appreciated,
Evan

evanr
Posts: 101
Joined: Thu Nov 29, 2012 3:09 am

Post by evanr »

did I buy a lemon?

all day at this and still no parts.

anyone here?

Korni
Posts: 6
Joined: Fri Feb 16, 2018 5:02 pm

Post by Korni »

Yes it is a SHAME ... NO Reactions ... NO German Support in this Forum :-(

thegabb3r
Posts: 3
Joined: Sun Dec 06, 2015 6:12 pm

Post by thegabb3r »

Have you tried contacting support directly? It usually takes less than 1 day to get a reply.

Post Reply