Z-axis jumps up and down

Post Reply
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Z-axis jumps up and down

Post by Mayhem »

Any idea why bed goes up and down at certain point? Or is that normal?
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Autodesk fusion 360

Posts: 62
Joined: Fri Mar 08, 2013 1:15 pm
Location: Finland

Post by kimmoli »

What slicer/profile did you use?

Posts: 132
Joined: Sat Jul 20, 2013 12:50 pm
Location: Würzburg

Post by Bachgassenbande »

Reract enabled?
If using the repetier host and SFACT is default on.
So everything ok!
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade

Post Reply

Return to “Troubleshooting”