Felix 3 - misaligned layers on the X-axis

Post Reply
User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Re: Felix 3 - misaligned layers on the X-axis

Post by gfeliksdal »

Dear Jfaria,

sorry to tell you but the ticketsystem didn't process your email due to technical difficulties. I assume you fixed it by now? Layer shift can also be caused by the pot-meter whcih is not properly adjusted. Did you check that?

Also please inspect the belt itself. Are all the teeth intact?

Kind regards,

Guillaume

Post Reply