Strang things spwitch back from ABS to PLA

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
angryangel
Posts: 110
Joined: Sun Mar 31, 2013 11:01 am
Location: Germany near Heilbronn / Heidelberg
Contact:

Strang things spwitch back from ABS to PLA

Post by angryangel »

hi

i triede to print a prinhead assemblie of abs this failed because the abs dont stick to the bed now i decided to isolate the bed and i orderd isoltion material
and until this arrives i switch back to pla to print some smal things

and now after the switch back my prins are much better but i dont know why

until yet i always heard that it is a problem to switch between abs and PLA

Post Reply