Hi,
Has someone tried Makerware (slicing software for the makerbot) to perform slicing?
It's like 20x faster than SFACT...!
Makerware
I just thought about it, installed it (it's free to download), dropped an .stl in it and sliced.
Of course, the program asks for a choice of a slicing profile and Felix isn't there.... But it should be possible to create a profile...
The .gcode imports then fine in Repetier Host and it shows proper, only with a different origin of X,Y.
Apparently the center of a Replicator is the 0,0). I don't know how to move it back on the table.
Of course, the program asks for a choice of a slicing profile and Felix isn't there.... But it should be possible to create a profile...
The .gcode imports then fine in Repetier Host and it shows proper, only with a different origin of X,Y.
Apparently the center of a Replicator is the 0,0). I don't know how to move it back on the table.
Felix 2.0
Hello
Try sending G92 Z0 X0 Y0 when you are in the middle of your print bed and your nozzle is at your Z-home poss. That way you tell the printer that this is your center and that you are on center, then hit print. Look in the g-code and remove any home moves.
Terje
Try sending G92 Z0 X0 Y0 when you are in the middle of your print bed and your nozzle is at your Z-home poss. That way you tell the printer that this is your center and that you are on center, then hit print. Look in the g-code and remove any home moves.
Terje