support

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

support

Post by Mayhem »

support is too close to the print how to change this and how can i reduce a mount of support being used?
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360
Top
Hugues
Posts: 272
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues »

I believe you will find an answer here:
http://www.felixprinters.com/forum/view ... t=10#p1982

That is, if you are using SFACT/Skeinforge
Hugues
Regards from Switzerland
Top
Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Post by Mayhem »

Thanks :)
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360
Top
Post Reply

Return to “General”