Felix 2 LCD Backlight?

Discussions about the electronics
Post Reply
User avatar
Kentxu
Posts: 20
Joined: Sat Jul 20, 2013 9:16 pm

Re: Felix 2 LCD Backlight?

Post by Kentxu »

Danny-Lelystad wrote:If i check the display connector on the Felix 2.0 pcb i get on all datalines (D0-D7) signals
Strange that you get all 8 data lines. It seems that in the PINS.h file only 4 are defined. Any I only saw 4 lines with data on my printer.
Perhaps you have different firmware...
Danny-Lelystad wrote:And you are right about quality control, this display should never be sent to u.
Also the main board had a dry joint.

seaton
Posts: 291
Joined: Tue May 14, 2013 9:04 am
Location: Bunbury, Western Australia
Contact:

Post by seaton »

Well Done, Glad you sorted it all out :)
Stephen...

Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ

http://blog.strobotics.com.au

Post Reply