Can i rotate support geometry?

Discussions about firmware/slicing software, tweaks and settings
Post Reply
maoz
Posts: 22
Joined: Mon Apr 15, 2013 9:54 am
Location: Saint-Petersburg, Russia

Can i rotate support geometry?

Post by maoz »

Can i rotate support geometry on any angle somehow in skeinforge like in slik3r?
My detail too large to rotate so the only one way to reduce material losess on support is to rotate it, because 2 vert. walls is parralel to support and i need to increase density of the support.

Kjetilei
Posts: 334
Joined: Fri Mar 16, 2012 8:26 pm
Location: Stavanger, Norway

Post by Kjetilei »

I don't think you can change the direction, but you might be able to overcome the problem by rotating the object 90-degrees on the table, or by enabling "Cross hatch instead of lines".

maoz
Posts: 22
Joined: Mon Apr 15, 2013 9:54 am
Location: Saint-Petersburg, Russia

Post by maoz »

Thanks but i can't rotate part because of it size.
And the cross hatch is hard to remove after. :cry:

Post Reply