just a thought: did you check if your extruder fan is working ?
also, based on what i can remember from when i unscrewed my extruder: there is no place for the plastic to go to like on your drawing. can you check that the top extruder part can screw completely into the bottom ?
Driving mechanism "eats" material
All fans is working & i tight extruder with pliers. And as i remember 1st part have a little bigger hole then the fillament - thats enought to melt out & get a bigger diameter.Hugues wrote:just a thought: did you check if your extruder fan is working ?
also, based on what i can remember from when i unscrewed my extruder: there is no place for the plastic to go to like on your drawing. can you check that the top extruder part can screw completely into the bottom ?
Maybe i should pump up the voltage to fans like here http://www.felixprinters.com/forum/view ... tage#p2326 ?

- Attachments
-
- very poor quality but nokia 6300 can't do it better ))
- Фото001[1].jpg (6.49 KiB) Viewed 207 times