Post Reply
Posts: 5
Joined: Sun Jan 14, 2018 2:53 pm


Post by Pannekoek »

I have twice got the message firmware requested pause. I was able to restart the printing process but I have no idea what is the course of the message because filament detection was disabled.
Can somebody help me?

User avatar
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands

Post by gfeliksdal »

Hi Pannekoek,

Normally this message only can be displayed when there is a filament detection but it can also appear when there is an error for for instance the heaters. Please check if the issue is not with that.

Post Reply