PLA sticking too well on the bed

Moderator: speedake95

Post Reply
Studiojohn
Posts: 12
Joined: Fri Mar 14, 2014 7:48 pm

PLA sticking too well on the bed

Post by Studiojohn »

Been using the Felix 3 now for quite a few years and had no problems at all, but just lately the PLA seems to stick like glue to the bed and will not come off cleanly thus destroying the part. Its very frustrating. I have tried different filaments and different settings. General I use the simple settings with slic3r. Any ideas on why the sudden change?

Post Reply