Duet control board

Discussions about the electronics
Post Reply
Deluka
Posts: 23
Joined: Sat May 03, 2014 5:05 am

Duet control board

Post by Deluka »

For the moment I have a vanilla TEC 4.1
But lately having a lot of problems with random under extruding and homing to the wrong place.
After checking and cleaning everything I can and recalibrating everything I think there is problem with the control board. Now I'm thinking about buying a duet. is there anybody here who has done this conversion successfully. Any advise is welcome

Deluka
Posts: 23
Joined: Sat May 03, 2014 5:05 am

Post by Deluka »

I made the move and bought myself a duet3d. the firmware settings are taken over and the printer does a fantastic job. it is now so quiet that the only noise now comes from the fans. the bed leveling is better. I never managed to use my full bed, but now I do. the endstops can be made to work by taking 5V from a free connection and placing a resistor. I1 can definitely recommend this upgrade

weigu
Posts: 8
Joined: Thu Dec 19, 2013 7:34 pm

Post by weigu »

Hi,

I pimped my Felix with a duet 3 6HC mainboard. More infos on:

file:///savit/www.weigu/other_projects/3d_printing/fe ... index.html

Post Reply