Custom slicing profiles

Discussions about firmware/slicing software, tweaks and settings
Post Reply
matteej
Posts: 23
Joined: Wed Oct 17, 2012 8:09 pm
Location: Netherlands
Contact:

Custom slicing profiles

Post by matteej »

I occasionally change some of the standard profiles that came bundled with the "setupRepetierHostFELIXPrinters_0_85.exe"-install file a little bit. I mainly change the support density, and the infill.
I was wondering what other people change in their slicing profiles, and if we could get a small database going for various situations.

naser404
Posts: 22
Joined: Sat Jan 19, 2013 4:17 pm

Post by naser404 »

I made many changes too, especially to speed & its running fine, so click on the speed tap and play around but make sure to make a copy of the profile your changing.

Post Reply