Trim pot tools

Discussions about the electronics
Post Reply
markus_kyroe
Posts: 46
Joined: Sun Aug 19, 2012 11:07 am

Trim pot tools

Post by markus_kyroe »

Hi,

I got everything working now, but I need to adjust the trim pots. The motors make a lot of noise! Which tool should i use. I see no carvings for a flag or Phillips screwdriver? I have bought a multi mini screw set, but none of them seem to really fit... :roll:

Kjetilei
Posts: 334
Joined: Fri Mar 16, 2012 8:26 pm
Location: Stavanger, Norway

Post by Kjetilei »

A mini Philips screwdriver should do the trick (or was it a regular slotted driver I used?)

I seem to remember that my screwdrivers also didn't fit really good but I managed to adjust it anyhow.

Good luck.

suraki
Posts: 27
Joined: Fri Aug 03, 2012 6:47 pm
Location: Hungary

Post by suraki »

I use the 1.8 mm regular one. it's perfectly fitted.
Unfortunately i fight a lot with extruder driver finetuning. :(

Post Reply