First test print!

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
danielkschneider
Posts: 49
Joined: Thu Apr 12, 2012 3:29 pm
Location: Geneva
Contact:

Re: First test print!

Post by danielkschneider »

Here is one. Drop into sfact_profiles/profiles/extrusion. Should print between 12 (1st layer) and 80mm/S (fills)
Attachments
LEGO-3 (normal).zip
(16.06 KiB) Downloaded 32 times

markus_kyroe
Posts: 46
Joined: Sun Aug 19, 2012 11:07 am

Post by markus_kyroe »

THANKS!!! Works perfect now ;-)

packman
Posts: 8
Joined: Sat Sep 22, 2012 2:02 am
Location: Cedar Grove, New Jersey, USA
Contact:

Post by packman »

Hi Markus,
I have encountered similar problems during the first run of my printer. What was the final solution on this? Ernie :|

markus_kyroe
Posts: 46
Joined: Sun Aug 19, 2012 11:07 am

Post by markus_kyroe »

I remember that there was i small mistake in the old manual i used during the installment of S-fact. A path was wrong, but was corrected in the updated manual.

Do you use S-fact? That is the only slicer that works for me :-)

packman
Posts: 8
Joined: Sat Sep 22, 2012 2:02 am
Location: Cedar Grove, New Jersey, USA
Contact:

Post by packman »

I use S-fact. My results are very similar to the picture you have at the beginning of the post. Which revision is the old manual you used. I used revision E.

Post Reply