It working but it doing wrong mouvements, see the video... it start good but after it doesnt run good and go away :http://youtu.be/BpQr9OtHubs
some body can help me?
don t print rigth
Moderator: speedake95
I haven't had the time to look through the whole video but jumped a little bit and might have missed something important.
It sounds like the x-axis stepper misses some steps (listen at 2:33).
If possible it would be great if you uploaded a new video with better sound: No radio and camera placed closer to the stepper motor and away from the fans to pick up the stepper sounds better.
The missing steps can be caused by wrong adjustment of the drivers causing less torque, friction in the belt setup or sliding bearing or the hot end hitting filament sticking up. It could also be caused by the pulley being a little bit loose.
It sounds like the x-axis stepper misses some steps (listen at 2:33).
If possible it would be great if you uploaded a new video with better sound: No radio and camera placed closer to the stepper motor and away from the fans to pick up the stepper sounds better.
The missing steps can be caused by wrong adjustment of the drivers causing less torque, friction in the belt setup or sliding bearing or the hot end hitting filament sticking up. It could also be caused by the pulley being a little bit loose.
- gfeliksdal
- Site Admin
- Posts: 405
- Joined: Sat Feb 25, 2012 10:40 pm
- Location: Netherlands
- Contact:
Another cause could be a bad connection with the x-axis optosensor...