Repertier Host

Discussions about firmware/slicing software, tweaks and settings
Post Reply
JimBass
Posts: 7
Joined: Sat Oct 13, 2012 12:51 am

Repertier Host

Post by JimBass »

I Just Downloaded Repetier Host 9.0
No profiles are included ???
New installation on this computer. Where do I look for the profiles

Help

Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues »

IIRC it was included in this downloadable file
http://shop.felixprinters.com/downloads ... =software/
Hugues
Regards from Switzerland

JimBass
Posts: 7
Joined: Sat Oct 13, 2012 12:51 am

Post by JimBass »

It may be in the .exe download but didn't make it into the "profiles" Folder when the setupRepetierHostFELIXPrinters_0_90.exe file was executed. I copied the profile from my old computer to the proper folder in this one and now they show up in Repetier Host. But I still have another problem.
The Printer "Homes" Correctly but won't move under Manual control after that in either the X or Z axis
I Notice that the Marlin firmware EEPROM settings are all at 0 steps per mm this does not seem right to me. The Y axis works under Manual control and it is also set to 0 steps per mm... Wierd The printer as well as the soft & firm ware used to work
I installed the Marlin from "Firmware_Marlin_Felix_1_0_Rev_D_v3(2).zip in the printer because I thought the firmware might be the source of my problems

Post Reply