Wiring Felix 2.0 - do all wires fit into the beam?

Help eachother out with assembly problems.
Post Reply
Jampac
Posts: 2
Joined: Sat Aug 24, 2013 1:25 pm

Wiring Felix 2.0 - do all wires fit into the beam?

Post by Jampac »

I'm trying to wire up the printer by following the instructions: squeeze all wires (incl. the two thick white head bed wires). I'm struggling to fit all of these into the beam and close them of with the black strip... Have I missed something?

Cheers form Australia

Bachgassenbande
Posts: 132
Joined: Sat Jul 20, 2013 12:50 pm
Location: Würzburg

Post by Bachgassenbande »

It fits in; but you have to arrange all lines pretty neat.
Did take some time and had to press hard to fit it in
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade

seaton
Posts: 291
Joined: Tue May 14, 2013 9:04 am
Location: Bunbury, Western Australia
Contact:

Post by seaton »

I found it very tight, I think it won't if I add a second extruder
Stephen...

Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ

http://blog.strobotics.com.au

Post Reply