Hi,
Just finished my felix 2.0 build.
Everything seems to be ok but the opto sensors dont work.
The green led lights are on but do not switch off when I put something in the groove.
Wired exactly as instructions indicate.
Any help would be appreciated, thanks
New build - opto sensors
i remember a recent thread on this forum about similar problems with the opto sensors,
i vaguely remember there was something with the wiring diagram...
thread is here if ever you haven't found it:
http://www.felixprinters.com/forum/view ... nsor#p3321
i vaguely remember there was something with the wiring diagram...
thread is here if ever you haven't found it:
http://www.felixprinters.com/forum/view ... nsor#p3321
Hugues
Regards from Switzerland
Regards from Switzerland