set-up FELIX 1.5

Discussions about firmware/slicing software, tweaks and settings
Post Reply
dennisje182
Posts: 8
Joined: Wed Jul 10, 2013 2:18 pm

set-up FELIX 1.5

Post by dennisje182 »

Hey guys,

I've got a Felix 1,5 here and I am having problems getting it properly connected to my Macbook.
I downloaded the drivers from http://www.ftdichip.com/Drivers/VCP.htm
I downloaded the firmware (Firmware_Marlin RC3_Felix_1_5.zip ) from the felixprinters website and uploaded it to the printer through the arduino software. When I connect with Repetier it still says "Unkown printer firm.... Waiting for temperature" and commands are queing. Anybody with an 1.5 can help get on the right way?

I did got it running in windows with the same software files......but still one question. It seems that it only prints out the "Normal quality-no support".....i can see all the profiles and i can select a different profile in Repetier, but when I check under the "configure" button of the sfact slicer it is still on "Normal quality-no support" and i can't change this....

Dennis

Post Reply