Foil Heater issue

Help eachother out with assembly problems.
Post Reply
faji911
Posts: 7
Joined: Tue Sep 24, 2013 3:37 am

Foil Heater issue

Post by faji911 »

Hi guys,

I'm currently assembling my Felix 2.0 printer, made a very stupid mistake and fixed the foil heater adhesive to the wrong side :roll: Unfortunately I realised too late, what I attempted was to slowly peel it off and stick it to the right side, it's quite bubbly but it is stuck on, I'm worried what issues this will cause me has anyone done the same thing? What problems could arise? Would I need a new foil heater adhesive to attach?

Cheers

Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues »

just a guess: air bubbles might inflate when temperature rises -> you should make a small hole with a needle in each big bubble.

Give it a try and see ! before ordering a new one, it might work
Hugues
Regards from Switzerland

faji911
Posts: 7
Joined: Tue Sep 24, 2013 3:37 am

Post by faji911 »

Thanks heaps mate, I'll give that a go!

Post Reply