LIVE STREAM

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
btron
Posts: 10
Joined: Thu Oct 10, 2013 12:21 am

LIVE STREAM

Post by btron »

Hey guys i have my Felix2.0 on my webcam atm. still has a few hours of print time.

http://www.australiawelding.com.au/webs ... index.html

i'll have the webcam online most the time when im printing.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Well, I hope you look at your printer, cause it's time to stop the print ;-)
felix-los.jpg
Your part came loose. Use these Avery stickers instead of kapton to prevent warping.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

btron
Posts: 10
Joined: Thu Oct 10, 2013 12:21 am

Post by btron »

satoer wrote:Well, I hope you look at your printer, cause it's time to stop the print ;-)
The attachment felix-los.jpg is no longer available
Your part came loose. Use these Avery stickers instead of kapton to prevent warping.
DOH!! hahahahahaha i live 20min drive away from my office.
ok so this is a fail print. i am geting a lot lift from the base. im using acetone to clean. should i use hairspray aswell? maybe a hotter base?

im also going to try Kisslicer next print after a few videos ive seen youtube.
Attachments
Fail01
Fail01
fail01.jpg (27.22 KiB) Viewed 226 times

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Like I said. Use these Avery stickers. These long parts are hard to print without warping. You might even need a larger brim around the object. Don't use acetone or any other cleaning product on the Avery stickers. I actually never clean it at all.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Makron
Posts: 110
Joined: Wed Mar 20, 2013 1:29 pm

Post by Makron »

Watching again :) I SEE A HAND !!!

btron
Posts: 10
Joined: Thu Oct 10, 2013 12:21 am

Post by btron »

as i am noob to cad and blender and most things 3d printed i have used this http://www.thingiverse.com/apps/customi ... 6dbadb6c48 from thingiverse.
i didnt have any of the avery stickers but i have the (PLA) base plate at 60deg and i dont see any lift...yet! and i cbf installing kisslicer today.
custom lid :D
custom lid :D
Screen Shot 2013-10-16 at 6.28.36 PM.png (125.16 KiB) Viewed 193 times
i will be printing the rest of the box in about 30mins from this post.

i will get the avery stickers some day soon.

btron
Posts: 10
Joined: Thu Oct 10, 2013 12:21 am

Post by btron »


Post Reply