Replacement Hot End Installation

Help eachother out with assembly problems.
Post Reply
Posts: 10
Joined: Thu Oct 10, 2013 12:21 am

Replacement Hot End Installation

Post by btron »

Hey guys. I have just received a new hot end and i have a few simple noobs questions.

Can i simply cut the old wires and solder these new hot end wires close to the hot end?


Are the wires +(pos) & -(neg) ?

Is it possible to connect the wrong wires?

Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Use at least 5cm distance from the hot-end for the solder joint / shrink tubing. Pos and neg don't matter, just don't reverse the thermistor and heater cables.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply

Return to “Assembly”