Felix Hotenend V4

This is the place to show off your felix printer hacks and improvements.
Post Reply
Posts: 132
Joined: Sat Jul 20, 2013 12:50 pm
Location: Würzburg

Felix Hotenend V4

Post by Bachgassenbande »

Anybody experience with the Felix V4 hotend?

I really would like to use this with the E3D direct bowden feeder design. If there are good experiences with the design according clogging and printing quality.

Any comparison according "oozing" (from V3 to V4)?
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade

Post Reply

Return to “Hacks and printer upgrades”