
FELIX 3.0
Moderator: speedake95
Re: FELIX 3.0
i was told by a store in australia when i got my felix2 that the dual extruder will be an upgrade. it was the main selling point for me.
i would pay for the stl/gcode + motors for this Felix 3.0 dual extruder.

-
- Posts: 132
- Joined: Sat Jul 20, 2013 12:50 pm
- Location: Würzburg
Yes why not; it's the same electronics
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
Hi all
I purchased a Felix 3.0 duel head DIY kit but they sent me a 2.0
The supplier said they could send me an upgrade kit when more stock arrives and that I could start using the 2.0 until it arrives.
So my question, is the 3.0 upgrade kit a full upgrade from the 2.0 or is it just some components (are the motors and electrics also the same), am I better off just sending the 2.0 back and waiting for the 3.0 to arrive.
Appreciate any advice you could provide me.
Thank you.
I purchased a Felix 3.0 duel head DIY kit but they sent me a 2.0
The supplier said they could send me an upgrade kit when more stock arrives and that I could start using the 2.0 until it arrives.
So my question, is the 3.0 upgrade kit a full upgrade from the 2.0 or is it just some components (are the motors and electrics also the same), am I better off just sending the 2.0 back and waiting for the 3.0 to arrive.
Appreciate any advice you could provide me.
Thank you.
Hello,
I'm going to get a Felix 3.0 printer, but does it print using ABS?
In some shops (http://3dprintersuperstore.com.au/produ ... kit-ex-gst)
ABS appear in specs.
Does someone tested ABS printing with Felix 3.0? Do you have any pictures available?
I'm going to get a Felix 3.0 printer, but does it print using ABS?
In some shops (http://3dprintersuperstore.com.au/produ ... kit-ex-gst)
ABS appear in specs.
Does someone tested ABS printing with Felix 3.0? Do you have any pictures available?
Yes it does, been printing out go pro cases in ABS tonight, only think I've added is insulation to the bottom of the print bedarhifane wrote:Hello,
I'm going to get a Felix 3.0 printer, but does it print using ABS?
In some shops (http://3dprintersuperstore.com.au/produ ... kit-ex-gst)
ABS appear in specs.
Does someone tested ABS printing with Felix 3.0? Do you have any pictures available?
Stephen...
Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ
http://blog.strobotics.com.au
Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ
http://blog.strobotics.com.au
-
- Posts: 12
- Joined: Wed Dec 18, 2013 12:58 pm
Tell us more about the insulation on the bed... and pictures please!