Really need an STL file plastic extruder

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Saamec
Posts: 157
Joined: Fri Jun 21, 2013 9:28 am

Really need an STL file plastic extruder

Post by Saamec »

Don't know what it's called. Does anyone have a STL file plastic parts extruder, which is stepper motor printer version 2.0 ? I looked at the forum not found. Really need this part, it cracked at the point of submission of plastic and plastic are not sent directly between the bearing and shaft, touches part hotend.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Saamec
Posts: 157
Joined: Fri Jun 21, 2013 9:28 am

Post by Saamec »

Just knew that help was you Satoer, thank you very much)

Post Reply