I have the printer for 4 months at the moment and last week the extruder motor start to make funny noices and is is turning back and forward a couple of degrees.
I checked the wires on the board there are connected up.
Have anybody some suggestions what this can bee?
Ramon
Extruder motor playing up
-
- Posts: 132
- Joined: Sat Jul 20, 2013 12:50 pm
- Location: Würzburg
Changed Slicer settings?
Retraction enabled?
Retraction enabled?
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
Wire is broken. 1 or more at the entrance of the wires in the stepper motor. This is due to the illiterate of the Assembly. Wires must be laid so that when moving extruder left-right was not bend the wire. I had it, I made out the stepper motor, made anew all the solder wires, new wires, put again in the cable channel and connected to the card. Now when moving wires not bend.
New hotend -- http://forum.felixprinters.com/viewtopic.php?f=9&t=729
-
- Posts: 46
- Joined: Sun Aug 19, 2012 11:07 am
I keep getting the same failure - it is the same as this right? http://www.youtube.com/watch?v=470UHVp_ ... e=youtu.be
Posted the same error here: http://forum.felixprinters.com/viewtopic.php?f=14&t=745
I'll go check my stepper motor to see if the wire is broken! I'll keep you updated!
Posted the same error here: http://forum.felixprinters.com/viewtopic.php?f=14&t=745
I'll go check my stepper motor to see if the wire is broken! I'll keep you updated!
-
- Posts: 46
- Joined: Sun Aug 19, 2012 11:07 am
It doesn't seem like the wire is broken in my case... How do I know for sure?
Do I have to open the back of the stepper motor to check? I have attached some pictures - I think that it is difficult to see anything. I have tried to pull a little bit in each wire but they seem to be firm...
Any suggestions?

Do I have to open the back of the stepper motor to check? I have attached some pictures - I think that it is difficult to see anything. I have tried to pull a little bit in each wire but they seem to be firm...
Any suggestions?
markus_kyroe wrote:я получаю же неудача - это же, как это право? http://www.youtube.com/watch?v=470UHVp_ ... e=youtu.be
Написал же здесь ошибка: http://forum.felixprinters.com/viewtopic.php?f=14&t=745
Я пойду проверить мои шагового двигателя, чтобы увидеть, если провод разбито! Я буду держать вас в курсе!
100% breakage of wires. I have exactly the same way. Remove the back cover of the engine and solder all the wires again. It is better to change the entire posting to the boards.
New hotend -- http://forum.felixprinters.com/viewtopic.php?f=9&t=729