Hello everyone, I'm new to the forum. I write from Spain.
I just buy a Felix 2.0. I have a problem. When I print out the parts symmetrical, do not go as the actual pieces. I have checked several times assembly, change something in the firmware?
Anyone know what to do?
Thank you.
Problem, symmetrical printed pieces
Moderator: speedake95
If you print a 1 x 1 x 1 CM cube, what are the exact measurements after printing? (and mark the X Y Z direction on the printed cube)
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
-
- Posts: 132
- Joined: Sat Jul 20, 2013 12:50 pm
- Location: Würzburg
And how?
Did you calibrate your printer?
Or did you have some other issues?
May the community can learn from your issue.
Thx
Did you calibrate your printer?
Or did you have some other issues?
May the community can learn from your issue.
Thx
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade