Dual head firmware sources

Discussions about firmware/slicing software, tweaks and settings
Post Reply
User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Re: Dual head firmware sources

Post by gfeliksdal »

To activate the EEPROM memory, the EEPROM_MODE should NOT be 0. The eeprom stays untouched when the same firmware is flashed, the only way to reset it is to give it a different value than it was before.

The connection timeout error should not be related to that single value in the firmware. It could be a driver problem, but it is strange that it can find the USB port, but not flash it. Are you able to just connect with repetier-host? On the electronics board standard the FELIX 2.0 single head firmware is flashed.

OleJunger
Posts: 7
Joined: Tue Dec 31, 2013 6:10 pm
Location: Reutlingen, Deutschland

Post by OleJunger »

I can connect with the repetier-host, but I cannot control anything!

OleJunger
Posts: 7
Joined: Tue Dec 31, 2013 6:10 pm
Location: Reutlingen, Deutschland

Post by OleJunger »

Wich is the correct Programmer? AVRISP mkII? Is that anyway important?

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

the programmer, is not important in this case. Have you tried it on a different computer, to rule out the driver issue?

OleJunger
Posts: 7
Joined: Tue Dec 31, 2013 6:10 pm
Location: Reutlingen, Deutschland

Post by OleJunger »

Yes, the first PC with win8.1 and the second with win7
Now I don't have any idea what I can do !

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

The only thing I can think of is that the board is defect. Or maybe the arduino chip is broken, due to flashing. Please return your board and we'll send you a replacement asap.

OleJunger
Posts: 7
Joined: Tue Dec 31, 2013 6:10 pm
Location: Reutlingen, Deutschland

Post by OleJunger »

OK I also think is last way. To which Adresse I habe to send the board?

difo
Posts: 1
Joined: Wed Jun 04, 2014 4:20 pm

Post by difo »

]THE PRINTER FELIX 3 WHEN PRINTING IS AN INCREASE IN SIZE ALONG Z AXIS VMESTO BALL EGG PRESIDENT OF RK HOW TO FIX. SIZES IN THE X AND Y PRINTS TRUE

Post Reply