Calibration for dual extrusion, how to measure?

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Lizzy Design
Posts: 17
Joined: Wed Nov 20, 2013 10:53 pm

Calibration for dual extrusion, how to measure?

Post by Lizzy Design »

Ok, just assembled the Felix 3 dual extrusion printer and made my thin wall test prints on both heads. The results were impressive. Didn't expect this from a DIY assembly (it probably helped I am prototyping a lot in my job and did the assembly on a dead flat grinded surface and made sure every angle was a spot on 90 degrees.)

I printed out the calibration dual extruder file. It states that both lines should be 20mm apart. My question is where do you start measuring from? From the outside, the center or the inside of the beads (since the bead/line has a width...)?

Post Reply