Hi!
I'm new in the 3d printed world... and I try to slice 3 printer spares parts... after 1 hour, only 25% was done....
With another software, it took like 30 seconds...
It is normal????
I try to copy/past the gcode and I fucked up my nozzle......... now I need to clean it.... grrr
1 hour for 25% only... for 3 littles pieces...?!?
The other software was 3dstuffmaker...
Thanks!
Sfact slicing very vvvveeeeerrrrrrrrrrry long....
-
- Posts: 7
- Joined: Wed Jan 01, 2014 11:36 pm
-
- Posts: 7
- Joined: Wed Jan 01, 2014 11:36 pm
Settings? I just set high quality ... Do i have other settings to do?
-
- Posts: 132
- Joined: Sat Jul 20, 2013 12:50 pm
- Location: Würzburg
Go for Kisslicer
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
-
- Posts: 7
- Joined: Wed Jan 01, 2014 11:36 pm
Kisslicer do i will be able to run the printer with that or just obtain the gcode?
-
- Posts: 7
- Joined: Wed Jan 01, 2014 11:36 pm
Yesterday, I tried to import gcode from 3dstuffmaker software to repetier-host...
My nozzle instantatly stop working (the pla doesn't go out)...
I found at the startup that the purge was not made (every piece sliced with repetier host do a purge before)... it is important to do the purge before print any piece?
My nozzle instantatly stop working (the pla doesn't go out)...
I found at the startup that the purge was not made (every piece sliced with repetier host do a purge before)... it is important to do the purge before print any piece?