Felix 3.0: leftover parts

Help eachother out with assembly problems.
Post Reply
Rauno
Posts: 9
Joined: Wed Jan 22, 2014 11:09 pm

Felix 3.0: leftover parts

Post by Rauno »

Hello everybody,

I have just assembled the Felix 3.0 following the assembly manual very carefully. Now I have a lot of parts left, that are not mentioned in the manual. A lot of bolts, nuts, a thermistor, two bearings (meant for the spool holder). Is this normal? Is the spool holder normally included or do I have to print it?

Thanks in advance,
Rauno

andrewsi
Posts: 130
Joined: Mon Dec 23, 2013 1:26 am

Post by andrewsi »

That's normal. A lot of extra parts are included, probably needed for the dual extruder version even if you only bought the single. You will have to print the spool holder parts yourself. So now you have spares!
__________________________________________
Andy Silverman, Technogeek in Seattle
Felix Tec4 Single-head

Rauno
Posts: 9
Joined: Wed Jan 22, 2014 11:09 pm

Post by Rauno »

Thanks for your quick answer. I do have the dual extruder version but still have a lot of mounting hardware left. I guess these are all replacement parts then.

Post Reply