I had the issue that the upper filament roll would always unwind when the lower one was used.
Also there was a lot of vibration in the stack.
I made this small turntable-arm like retention tool for the upper filament coil.
It needs something sticky like a rubber band at the end to keep the coil from unwinding.
Picture:
:wq
D.Herrendoerfer
Last visit was:
It is currently Wed Jan 20, 2021 8:01 am
Dual filament unwind stopper
Discussions about mechanics
-
- Posts: 4
- Joined: Sun Jan 26, 2014 9:28 pm
Jump to
- General
- ↳ Official FELIXprinters News
- ↳ FELIXprinters.com feedback
- Hardware
- ↳ FELIX Pro Series
- ↳ General Discussion
- ↳ Assembly and first print
- ↳ Electronics
- ↳ Mechanics
- ↳ Troubleshooting
- ↳ Hacks and upgrades
- ↳ FELIX Tec Series
- ↳ General Discussion
- ↳ Assembly and first print
- ↳ Electronics
- ↳ Mechanics
- ↳ Troubleshooting
- ↳ Hack and upgrades
- ↳ FELIX Pro L Series
- ↳ General Discussion
- ↳ Assembly and first print
- ↳ Electronics
- ↳ Mechanics
- ↳ Troubleshooting
- ↳ Hack and upgrades
- ↳ Additional Hardware
- ↳ Extruders & Hotends
- ↳ Older FELIXprinters upgrades
- ↳ Archive
- ↳ Hacks and printer upgrades
- ↳ Troubleshooting
- ↳ Assembly
- ↳ Mechanics
- ↳ Electronics
- ↳ General
- Software/Firmware
- ↳ FELIXbuilder
- ↳ Simplify3D
- ↳ Repetier-Host
- ↳ Kisslicer
- ↳ CURA
- ↳ Firmware
- ↳ General
- ↳ PrusaSlicer
- The Art of 3d printing
- ↳ Tips and Tricks
- ↳ What have you made? Show off your projects
- Materials
- ↳ FELIXprinters filaments
- ↳ Other filaments
- ↳ Troubleshooting
- ↳ General
- Languages
- ↳ Nederlands
- ↳ Deutsch
- ↳ Español
- ↳ Italiano
- ↳ português
- BIO-printing
- ↳ BIO-INK
- ↳ Alginate
- ↳ Gellan gum
- ↳ Agarose
- ↳ Gelatine
- ↳ Collagen
- ↳ Pluronics
- ↳ PEG
- ↳ Applications
- ↳ Validated
- ↳ Non-Validated
- ↳ Print file library
- ↳ Q&A
- ↳ Publications
- ↳ Comments, requests, and suggestions
- Back to Main Website Board index
- All times are UTC+01:00
- Delete cookies
- Privacy
- Terms
- Contact us