Yes, I glued it directly to bottom side of bed (there was some sort of plastic on it).
I used hobby glue from Pattex, nothing very special.
My bed temperature does not go above 90°
I taped white insulation underneath the bed, something like polyurethane used for packaging transformers that were sent to me, got to 104 degrees celsius with 70 percent of the bed covered.
I have a v3 felix so no problem for the extruder carriage, although I don't get why the extruder carriage would suffer from 100 degrees at the print bed when de extruder goed up to 250 and more...?
I have a v3 felix so no problem for the extruder carriage, although I don't get why the extruder carriage would suffer from 100 degrees at the print bed when de extruder goed up to 250 and more...?
My bed temperature does not go above 90C too. I already tried insulation with felt or foam rubber.
Without insulation i got 84C (after 10 Minutes), with insulation 93C (84 after 10 min, 93 after 45 min!).
Any suggestions? Wrong material? Electronics-Problem? inssuficient power?)
BTW, i own a felix 3.0
tia.
Without insulation i got 84C (after 10 Minutes), with insulation 93C (84 after 10 min, 93 after 45 min!).
Any suggestions? Wrong material? Electronics-Problem? inssuficient power?)
BTW, i own a felix 3.0
tia.